Appliance Error Code Guide Codes, causes & fix order
Diagnosis by symptom

Fridge Not Cooling, Freezer Still Frozen

A freezer that still freezes tells you the compressor and sealed system are probably alive. That single fact moves the diagnosis to the air path between the two compartments — and to the parts that live there.

Reviewed against manufacturer cooling-system documentation Updated 16 November 2026 10 min read

The short answer

  • What it proves: the compressor is running and refrigerant is moving. The fault is in the air path to the fridge section.
  • Most likely first: the fridge evaporator fan has stopped, or the air duct/damper between compartments is blocked or iced.
  • Then: a defrost failure icing the coil, a failing fridge thermistor, a stuck damper motor.
  • Free check first: make sure the fridge is not packed against the rear air vents, and confirm the door seals.

Food first, for two minutes

  • Move meat, dairy and leftovers into the freezer or a cool box with ice packs.
  • Keep both doors closed between checks.
  • Discard anything that has been above about 4 °C for over two hours, and anything that smells wrong. Do not re-freeze thawed meat.
  • Put a thermometer in a glass of water in the fridge: you need a real number, not a hand on a shelf.

How a fridge cools two compartments

Most frost-free refrigerators have one evaporator and one compressor. Cold air is produced in one place and distributed: some designs run a fan for each compartment, others use a single fan with a motorised damper that opens and closes the path to the fridge section. A few use twin cooling circuits, one per compartment, which changes the diagnosis.

That is why "freezer fine, fridge warm" is such a good clue. The production side works; the distribution side does not.

DesignWhat controls fridge airWhat fails
Single evaporator, single fan, damperA motorised damper plus a shared fanDamper stuck shut, damper motor, iced duct
Single evaporator, two fansA dedicated fridge evaporator fanFridge fan motor, ice on the coil
Twin coolingSeparate evaporator and fan per compartmentFridge-side fan, sensor, or its own defrost circuit

The six causes, in order

1. The fridge is blocking its own air vents

Packing the rear wall stops cold air leaving the duct. Pull everything forward by 5 cm, clear the vents, and leave the rear space free. On a bottom-freezer model the fridge is cooled from the freezer below, so the path is at the back of the fridge compartment.

2. The fridge evaporator fan has stopped

Open the door, find the door switch and press it (or hold it in), and listen for the fan. A silent fan, a ticking fan or a fan that stops when it gets cold points at the motor or its connector. Ice around the blade means the defrost system, not the motor.

3. A defrost failure has iced the coil

Frost builds until air cannot pass. The signature is a fridge that fails every few days and recovers after a manual defrost. The parts are the defrost heater, its sensor or thermal fuse, and the relay on the control.

4. The damper is stuck shut

On single-fan designs the damper controls the fridge temperature. A failed damper motor leaves it shut, so the fridge warms while the freezer is unaffected. In test mode the control usually drives the damper, which is the quickest confirmation.

5. The fridge thermistor is reading wrong

If the sensor tells the control the fridge is already cold, the control stops cooling it. The symptom is a fridge that is warm while the control behaves as though everything is fine — and often no code at all.

6. Door seal, hinge or a blocked drain

A torn seal or a door that does not close on its hinge lets warm air in continuously; a blocked defrost drain leaves standing water that freezes and blocks the air path. Both are cheap to check and cheap to fix.

Unplug before removing an interior cover, and never use a knife or screwdriver to chip ice. The evaporator's refrigerant lines are immediately behind the fins and a puncture cannot be repaired at home. Leave the sealed system to a qualified technician.

Narrowing it in ten minutes

ObservationPoints to
Fan silent with the door switch pressedFan motor or connector
Fan ticking or scrapingIce around the blade — defrost fault
Heavy frost on the rear panel of the freezerDefrost system
No frost anywhere, fridge still warmDamper, thermistor or fan
Fridge cold at the back, warm at the doorAirflow or a seal problem
Water pooled at the bottom of the fridgeBlocked defrost drain

If a code appears

This fault often comes with a code on a modern cabinet. The same symptom appears as 22E on many Samsung models, Er RF on LG, and an F-code on Whirlpool. Reading the code narrows the part; the order of checks above still applies.

Repair or replace

Fans, dampers, thermistors and defrost parts are moderate and worth replacing on a cabinet that seals well and shows no rust. A sealed-system diagnosis — low refrigerant, a restricted capillary, a failing compressor — is the expensive category, and it is worth a second opinion before you accept it, because it is the diagnosis that most often ends in a new fridge. Repair or replace explains how to weigh that honestly.

Frequently asked questions

Can I use the freezer while the fridge is warm?

Yes, if the freezer is holding −18 °C. Keep the fridge door shut as much as possible so you do not add load to a system that is already working hard.

Why does it work again after I defrost it manually?

Because you removed the ice that was blocking the air path. The defrost system that should have removed it is the actual fault, and the ice will return within days.

Is a warm fridge with a cold freezer always repairable?

Usually, because the compressor is working. It is the diagnosis of a sealed-system fault on a machine that still freezes that deserves scepticism.

Sources

  1. Manufacturer support documentation for compartment temperature faults: Samsung, LG, Whirlpool and GE consumer support sections, accessed 16 November 2026.
  2. Service documentation on single-evaporator air distribution, dampers and defrost cycles.
  3. Editorial review against the parts trade: fan, damper and defrost failure patterns across frost-free platforms.

General information only. Air-distribution design differs between single-evaporator, twin-cooling and bottom-freezer cabinets. Confirm against your model's documentation, unplug before interior work, and leave sealed-system repairs to a qualified technician.