Appliance Error Code Guide Codes, causes & fix order
Refrigerators · Samsung

Samsung Refrigerator Error Codes

Samsung fridge codes are numbered by circuit, not by symptom: 21 to 29 for the fridge side, 31 to 49 for the freezer and defrost systems. The number tells you which part of the box stopped working.

Checked against Samsung support documentation Updated 16 November 2026 10 min read

The short answer

  • 21E / 22E — fridge-side fan fault. The fridge warms; the freezer keeps freezing.
  • 41E / 42E — freezer-side fan fault. Both compartments eventually warm.
  • 39E (and the 3x series) — defrost circuit: heater, sensor or relay. Ice builds on the evaporator.
  • OF / OF OF — a compartment's sensor is disconnected or reading open on models that display it; confirm in your manual.
  • Food first: move what you can into a cool box or the freezer before you start diagnosing.

Food safety before diagnosis

A refrigerator fault is a food-safety problem with a technical cause. Before you open a panel:

  • Keep the doors closed while you decide — a closed fridge holds temperature for hours, an open one for minutes.
  • Move high-risk food (meat, dairy, cooked rice, leftovers) into a cool box with ice packs or into the working freezer compartment.
  • Discard anything that has been above about 4 °C for more than two hours, and anything with an unusual smell. Re-freezing thawed meat is not worth the risk.

How Samsung numbers its fridge codes

Samsung's refrigerator diagnostics use a two- or three-character code where the number identifies the circuit and the letter identifies the fault type. Across the French-door, side-by-side and bottom-freezer platforms the scheme is consistent enough to be useful:

CodeCircuitTypical symptomFirst check
21EFridge fan / airflowFridge warm, freezer fine, fan noise or silenceIce on the evaporator cover, fan obstruction
22EFridge evaporator fanFridge section warm, uneven coolingFan blade clearance, motor connector
41EFreezer evaporator fanBoth sections warm over a dayIce build-up, fan motor
42EFreezer fan feedbackFan runs but is not detectedHarness and connector at the fan
38E / 39EDefrost sensor / heaterHeavy ice, fridge warms every few daysEvaporator ice pattern, heater continuity
24E / 25EIce maker / ice roomNo ice, ice room warm, frost in the ice bucketIce maker fan, water supply, fill tube
OF / OF OFSensor openCompartment not cooling, no other codeSensor connector (model-specific; check the manual)

Codes vary between platforms and model years — a Bespoke French-door and an older side-by-side do not share every number. Where your display shows a number not listed, the code page in your model's manual is authoritative, and the diagnostic logic below still applies.

Fan faults: 21E, 22E, 41E

A refrigerator moves cold air from the evaporator into the compartments with fans. When a fan stops, the compartment it serves warms while the rest of the cabinet may look normal — which is why "the freezer is fine but the fridge is warm" is so often a fan code.

  1. Listen. Open the door and press the door switch (or hold it closed with tape on some models) so the fan runs. A fan that is silent when it should run, or that ticks, is the suspect.
  2. Look for ice. Remove the evaporator cover inside the compartment and inspect the coil. A coil encased in ice means a defrost fault, not a fan fault — the fan cannot turn inside a block of ice.
  3. Clear the blade. Ice, a plastic bag or a displaced blade can stop the fan. Clear it and check rotation by hand.
  4. Connector and motor. Check the plug at the fan for corrosion or a loose pin, then replace the motor if it has supply but does not turn.

Defrost faults: the 3x codes

A defrost system runs a heater for a short period every several hours to melt frost off the evaporator. When it stops working, frost builds until airflow is blocked: the freezer still freezes, the fridge warms, and after a manual defrost everything works for a few days before failing again.

That cycle — works after defrosting, fails within a week — is the signature. The parts involved are the defrost heater, the defrost sensor (thermistor), the thermal fuse on some platforms, and the relay on the control board.

Unplug before removing any interior cover, and never chip ice off an evaporator with a knife. The refrigerant lines sit directly behind the coil and a puncture cannot be repaired at home. Leave the sealed system and any inverter board work to a qualified technician.

Resetting the display

Some codes clear on a power cycle: unplug for five to ten minutes and reconnect. That is worth doing once, because a transient voltage dip can latch a code with nothing wrong. If the code returns within a day, it is real. Do not cycle power repeatedly on a fridge that is not cooling — you are only losing temperature.

Repair or replace

Fans, sensors and defrost heaters are moderate parts and normally worth replacing on a fridge under about ten years old. A sealed-system fault — compressor, inverter board, a leaking evaporator — is the expensive category, and the decision turns on age, insulation condition and how much food you would lose. Repair or replace sets out the comparison; fridge warm and freezer cold covers the machine with no code at all.

Frequently asked questions

Can I use the fridge while waiting for a part?

Only if both compartments are holding temperature. A fridge running with a failed evaporator fan will warm unevenly and may freeze food near the vent while the rest spoils.

Why does the code come back after a manual defrost?

Because the defrost system is still not working. Manual defrost clears the ice, not the cause; the ice returns within days.

Does a fan fault damage the compressor?

Indirectly, yes. Poor airflow makes the compressor run longer and hotter, which shortens its life. Fixing a fan early is cheap insurance.

Sources

  1. Samsung Support — refrigerator error code guidance and troubleshooting articles for fan and defrost faults (samsung.com support sections for US, UK and EU markets), accessed 16 November 2026.
  2. Samsung service documentation on evaporator fans, defrost circuits and the sensor layout.
  3. Editorial review against the parts trade: fan motor, defrost heater and sensor failure patterns in French-door and side-by-side cabinets.

General information only. Code numbering and part locations differ between Samsung refrigerator platforms. Confirm against your model's manual, unplug before interior work, and leave the sealed refrigeration system to a qualified technician.